<<-- Back to the support page
Permanent Installation Instructions
step five
Take the long, 3 way cable, that came with the USBtribe. Connect one end to the USBtribe connector marked SERIAL and the other end to the Monotribe connector marked SERIAL, located on the left side of the Monotribe board. Connect the 6 way cable, previously disconnected from the Monotribe's base, to the USBtribe connector marked 'SYN'.
step six
Now we need to make a small, semi-circular opening, in the wall of the base, to pass the USB cable through. You'll need a round file, of similar diameter to the USB cable. With the base oriented as shown in the photo, carefully file the opening in the lower right corner, on the horizontal edge, close to the screw pillar. File a little at a time, regularly checking the size against the cable.
<<-- Back to the support page